進口ODE柱塞式電磁閥,ODE柱塞式電磁閥工作原理
There are also two shutters in the combined operation and in the pilot
control solenoid valves, one acting on the pilot orifice and the other on the main orifice.
Sometimes shutter function is carried out directly by the diaphragm or piston.
具有導控制的2路常開電磁閥具有入口管和出口管。
關于運動，這些電磁閥的功能的膜片，與2通常相同關閉電磁閥，帶導控制，
常閉套件的常用開放套件的位置安裝以打開和關閉導向孔。
此外，在設計液壓回路以解決問題時必須特別注意的水錘，
可能導致過壓，如撕裂隔膜或損壞電磁閥的其他部件。
Shutter (or sealing gasket): this component may be housed directly in the plunger, in a gasket

進口ODE柱塞式電磁閥,ODE柱塞式電磁閥工作原理
housing, in the piston, or be part of the complete diaphragm. With a movement the shutter
opens or closes an orifice thus permitting or preventing the flow of fluid.
為了正確操作電磁閥，并避免膜片的快速磨損，建議一次啟動閥關閉，
實際流量不高于Kv（即：流量通過閥，壓力損失為1巴）。
因此，如果閥門打開時的入口壓力，高于1巴，就是不建議使用具有自由出口的閥本身，
即沒有出口限制帶來壓力下降到1巴的值。
Certain valves have more than one shutter, for example the three way direct action solenoid
valves: the two shutters, housed at the ends of the fixed core, alternay open and close the
inlet and outlet orifices.
 

,ODE柱塞式電磁閥工作原理